Insert the hot end back into the carriage and install the M3 screw to hold it in place.
If needed, flip the fan and fan shroud around so the fan points out and the wires easily reach their respective connectors.
Make sure that the long end of the heat block does not stick out toward the rear of the printer. It must be oriented in such a way that it will not come into contact with the printer frame during homing.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.