Place the of the thermistor into the hole, and fasten in place using the smaller M3x4 screw and washer.
Use your fingernails to keep the sleeving under the washer whilst tightening.
Visually check that the blue sleeving is isulating the legs of the thermistor right down to the bead. If the legs make electrical contact with the block or each other your temperature readings will be incorrect and you risk overheating.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.