Plug in the connectors for the thermistor and the heat sink fan. Make sure that the thermistor goes to the white wires and the layer cooling fan goes to the purple/yellow wires.
You may want to mark the connectors with a sharpie so they do not get confused in the future.
Slide the sheath down over the wires and wrap the end with the original fabric tape, if you still have it.
Secure the wire harness to the bowden tube using a zip tie.
Also use a zip tie on the hot end wires to organize them and hold them together.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.