Strip 2 cm from the ends of the yellow and purple wires that were connected to the original heat sink fan.
Cut two pieces of 3 cm long heat shrink tubing and slide them onto the yellow and purple wires.
Twist the yellow and purple wires to the red and black wires from a connector you prepared in the last step.
Yellow goes to red.
Purple goes to black.
Solder the connections.
Slide the heat shrink tubing down over the connections and use a heat gun to shrink it.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.