We now need to splice the proper connectors onto the printers wiring. We will use the connectors from the wires that came in the E3D kit.
You can use a zip tie to hold the sheath out of the way while you work.
Take the two wires provided in your E3D kit and cut a 10 cm length from each. Use the end with the large connector.
Strip 2 cm from the ends of the wires.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.