Some of the lakes in the model didn't quite come out flat, so we're going to manually flatten them.
Zoom in to the area you want to flatten.
Press Tab to enter Edit mode again.
If the grid around the area you want to flatten isn't very high definition, you can subdivide the grid into smaller squares.
Change to Face select mode by clicking the icon at the bottom of the screen of the cube with one side highlighted.
Press the C key to use the Circle select tool, and use your mouse cursor to make the selection area bigger or smaller.
Select all the faces over the area you want to have more definition, then press Escape to exit Circle select mode.
Press the W key and choose Subdivide. You can do this more than once to get more definition, but be careful as too much detail can add unnecessary complexity to the model.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.