Do this in a well ventilated area.
Place the lid on the can.
Do not seal the lid tightly. If the vapor cannot escape, the can will explode.
We drilled a hole in the lid to act as a vent and also to allow us to insert a temperature probe.
Place the can on the hot plate and turn on the heat to the lowest setting. When set to "Warm" our hot plate kept the temperature stable at 55 °C (130 °F).
Set a timer for 15 minutes and check the print every 5 minutes.
DO NOT BREATHE THE ACETONE VAPORS
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.