Some of the engine bells are very thin on the end. To deal with this, we just used bottom clipping, so it would skip the first few layers which are too thin to print.
Remember to turn off bottom clipping before your next print.
Support material will almost undoubtedly be required. Our standard recommended support material settings are...
Overhang Threshhold: 30 degrees
Pattern Spacing: 2.5 mm
Interface Layers: 0
Z Gap: 1 layer
Detailed models like this are prone to stringing. To minimize this, have a look at our guide on optimizing retractions.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.