Move the printer's delta arms back into operating position.
Connect the printer to MatterControl and set the extruder temperature to 260°C.
The hot end fan should start up once the temperature is set to any temperature higher than 50°C.
Using a 7mm socket wrench and an adjustable wrench or tongue-and-groove pliers to hold the heat block steady, tighten the nozzle.
Do not over-tighten; one firm adjustment in the right direction is sufficient.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.