Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #9

Edit by MatterHackers

Edit approved by MatterHackers

Deleted
Added
Unchanged

Step Lines

[* yellow] Remove the two hex 1.5mm screws securing the X-axis endstop to the stock layer cooling fan shroud and lay the endstop aside.
[* icon_note] Make sure to keep
aside with the wires still connected.
[* blue] Set the washers aside for reuse, but screw
the screws as theyback in to place temporarily after the endstop has been removed. We will be reused for reassemblyuse them to remove the insets in the next step.
[* icon_note] If you have extra M2 insets, you can skip the next step
.
[* yellow] Remove the two hex 1.5mm screws securing the X-axis endstop to the stock layer cooling fan shroud and lay the endstop aside.
[* icon_note] Make sure to keep
aside with the wires still connected.
[* blue] Set the washers aside for reuse, but screw
the screws as theyback in to place temporarily after the endstop has been removed. We will be reused for reassemblyuse them to remove the insets in the next step.
[* icon_note] If you have extra M2 insets, you can skip the next step
.

Image 2

No previous image

Added