Site Navigation

Your Account

Choose Language

Changes to Step #32

Edit by Ryan Lutz

Edit approved by Ryan Lutz

Deleted
Added
Unchanged

Step Lines

[title] Torque down nozzle
[* black] Bring[https://www.matterhackers.com/articles/mattercontrol-getting-started#connectingtoaprinter|Connect the hotend upprinter to temperature (260C)MatterControl] and then tighten downset the nozzle with a wrenchextruder temperature to 260°C.
[* icon_caution] If this step is omitted the nozzle will work its way loose fromblack] Using a 7mm socket wrench and an adjustable wrench or tongue-and-groove pliers to hold the heat block and plastic will ooze fromsteady, tighten the threadsnozzle.
[* icon_caution] Do not over-tighten; one firm adjustment in the right direction is sufficient
.
[* black] Bring[https://www.matterhackers.com/articles/mattercontrol-getting-started#connectingtoaprinter|Connect the hotend upprinter to temperature (260C)MatterControl] and then tighten downset the nozzle with a wrenchextruder temperature to 260°C.
[* icon_caution] If this step is omitted the nozzle will work its way loose fromblack] Using a 7mm socket wrench and an adjustable wrench or tongue-and-groove pliers to hold the heat block and plastic will ooze fromsteady, tighten the threadsnozzle.
[* icon_caution] Do not over-tighten; one firm adjustment in the right direction is sufficient
.

Image 1

No previous image

Added