Site Navigation

Your Account

Choose Language

Changes to Step #3

Edit by MatterHackers

Edit approved by MatterHackers

Deleted
Added
Unchanged

Step Lines

[* black] Insert the heater cartridge into heat block of the E3D hotend.
[* black] Secure the cartridge using provided screw and 2mm allen wrench.
[* icon_note] Note: The MakerBot uses a 24 volt heater cartridge. Use the original cartridge, but in the event that the part needs to be replaced be sure a [http://www.matterhackers.com/store/printer-accessories/e3d-heater-cartridge-24v|24 volt heater cartridge] is used.

Image 1

No previous image

Added