Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Flashing the Bootloader on a Creality CR-10 Introduction

Edit by MatterHackers

Edit approved by MatterHackers

Deleted
Added
Unchanged
Conclusion
Now that the bootloader is flashedCongratulations, you will need are now ready to install a new firmware. Before firmware on your CR-10. We recommend that you try uploading the firmware before closing up the control box, try uploading a firmware to your printer. This will make sure box so that you know the bootloader is working properly. properly before you put everything back together.
Now that the bootloader is flashedCongratulations, you will need are now ready to install a new firmware. Before firmware on your CR-10. We recommend that you try uploading the firmware before closing up the control box, try uploading a firmware to your printer. This will make sure box so that you know the bootloader is working properly. properly before you put everything back together.